Denver, CO · Sub-Zero
Ice Maker Repair
Harvest faults, scale and leaks on Sub-Zero clear-ice modules and the water path behind them.
$89 flat: the trip, and a diagnosis you get told the result of. Approve the work and the same $89 comes off the total.
How it usually gets described
- No harvest at all, or a mould that never empties
- Cloudy, hollow or fused cubes
- Scale from hard city water choking production
- Water pooling under the bin and refreezing
What gets checked
- Which module the generation actually uses established from the model before any part is ordered
- Fill cup, mould and ejector inspected for scale — the usual finding on Denver water
- Inlet valve, fill volume and line pressure measured, and the filter age established
- Harvest watched end to end instead of assumed, bin sensor included
What it costs
The six bands a quote comes out of
Parts, and the labour to fit them, grouped the way faults actually turn up on a built-in. Yours lands inside one of these before anyone reaches for a screwdriver.
The visit and a full diagnosis are $89 flat. Approve the repair and that $89 comes straight off what you pay.
One firm figure from inside the band, settled with you first. Nothing is dismantled and nothing is ordered until you have said yes to it.
- Door seal or drawer gasket
- $270–$680
- Fan motor, evaporator side or condenser side
- $320–$700
- Defrost circuit: heater, limit or thermistor
- $280–$610
- Ice module, inlet valve or fill line
- $260–$750
- Control board or user interface
- $390–$1,000
- Sealed system: compressor, drier or charge
- $1,490–$3,180
Ranges, not starting prices. Two things move a figure inside its band: which part it turns out to be, and how far the cabinet has to come out of the run before anyone can reach it. Set against that, a new built-in of the same width, with no cabinetry or fitting counted in, is $11,900–$23,680.
Ice modules changed between generations, so have the model read off the plate . An ice maker on an older cabinet is the usual place to meet a number that is no longer supplied . Scale from city water shows up first here and in Five Points .
The other three on this equipment
- Refrigerator Repair Fresh-food circuits on built-in, integrated and undercounter cabinets, from the 500 Series onward.
- Freezer Repair Freezer columns and drawers that frost up, drift warm or stop clearing the evaporator.
- Wine Cooler Repair Zone drift, glass-door condensation and fan noise on Sub-Zero wine cabinets and undercounter units.
Reviews
What owners say once the van has gone
Built-in calls in Golden Triangle, Five Points, Virginia Village and Belcaro.
4.9/ 51,739 reviews
Our bin was filling with cubes fused into one lump every couple of days. He diagnosed a lazy harvest cycle and a bin sensor covered in film. Both handled, though he came at the very end of the window.
Roswell E.Five Points
Cubes came out hollow and tasted like the back of the freezer. He replaced the inlet valve, then swapped a filter that had clearly never been changed since the loft conversion. Ice is clean and clear now.
Quillan H.Five Points
Cubes turned small and cloudy days before we had thirty people over, and I assumed the module was finished. It came down to low water pressure at the unit and a partly plugged screen. Cleaned, fill adjusted, full cycle watched.
Ulysses G.Belcaro
Two ways in, and nothing to fill in
Give us the model number and what the cabinet is holding. That is usually enough to know which circuit is at fault before anyone is dispatched — and which parts belong on the van.